ciao a tutti, this is where I have gone so far ...
The next two pictures are a view of the bezel from the back of the watch once the module
has been removed :
IMG00907.jpg
IMG00908.jpg
it would looks that there is no way to take it out from this side.
I have used a sharp knife all around, but it didn't came out.
However, because of the knife inserted, it had slightly enough
changed the shape, so that the module did not fit in to the watch
anymore.
With some sandpaper, I have slimmed the module and enlarged
the bezel, so that it goes in back again.
Still, the curiosity on how and from which side this bezel can removed remains,
so if any has ever done it, pleast post a comment on it.
Polishing :
I have sandpapered the glass, yes is in plexiglass, and the front of the watch.
The finest grade I have is 2000, then, it has been polished, but I can't get the
mirror look I would like to see.
Also, there is a comparison between the left side (which I have began to treat at 3 am this
morning) andthe stem side, which is untouched.
I know it's far from being fineshd, but please, tell me it was worth ....
IMG00910.jpg