Pulsar P3 module dead!!

[horror_logic]

Hi
Just wondered if there is anything i can try to revive a Pulsar 3013 module, Its is totaly dead, contacts have been cleaned and i have connected to 3v power supply, no current draw whatsoever. Tried the hair dryer to see if that would do anything, still dead.
Where do i go from here ??

Thanks

[Huertecilla]

Hi
Just wondered if there is anything i can try to revive a Pulsar 3013 module, Its is totaly dead, contacts have been cleaned and i have connected to 3v power supply, no current draw whatsoever. Tried the hair dryer to see if that would do anything, still dead.
Where do i go from here ??

Thanks

If all contacts that should make contact do so and nothing that should not does not, drop Strikes&spares a mail and send them the watch.

[retroleds]

Hi
Just wondered if there is anything i can try to revive a Pulsar 3013 module, Its is totaly dead, contacts have been cleaned and i have connected to 3v power supply, no current draw whatsoever. Tried the hair dryer to see if that would do anything, still dead.
Where do i go from here ??

Thanks

Try swapping the quartz crystlal....crystal fully blown, no juices flow.

[horror_logic]

Thanks guys, will try the crystal first, then most likely post of for repair :)