04 Mar 2012, 13:45
ciao a tutti,
this module had suffered from bleeding.
I believe it was the glue that was keeping together the two glasses of the LCD,
and this was preventing the setting lever from moving, since it was stuck and
glued to the pcb.
I have removed all the leverages and tried to clean the glue with some solvents.
I have succeded, since now the lever can move and this will allow the setting button
to move freely.
But, looks like one of the products used has melted the bottom part of the module.
I believe this put the module beyond any hope of working .
Doeas anyone in the forum knows is the IC module of a 634 is compatible and
can be swapped with this ?
Thanks for help, Alberto
this module had suffered from bleeding.
I believe it was the glue that was keeping together the two glasses of the LCD,
and this was preventing the setting lever from moving, since it was stuck and
glued to the pcb.
I have removed all the leverages and tried to clean the glue with some solvents.
I have succeded, since now the lever can move and this will allow the setting button
to move freely.
But, looks like one of the products used has melted the bottom part of the module.
I believe this put the module beyond any hope of working .
Doeas anyone in the forum knows is the IC module of a 634 is compatible and
can be swapped with this ?
Thanks for help, Alberto
You do not have the required permissions to view the files attached to this post.
Alberto Fenini
alberto.fenini@consys.it
alberto.fenini@consys.it