Here's a few photos of the original battery next to a 2320 "standard" battery that I'm going to try to use.
The old battery is 23 mm x 1.5 mm. The new battery is 23 mm x 2 mm
As indicated in the above thread, you can see a "ledge" on the original battery that slips under the blue tabs in two locations on the "left side" of the picture.
Of course there's that pesky (negative) tab on the back of the original battery as well.
As mentioned above - I'm going to attempt to nibble the blue tabs off so the new battery makes better positive contact on the sides, and lift the tab on the bottom hoping it makes better contact on the bottom of the new battery.
I have a new tool for this - my xacto retractable pen knife blade.
IMG_2390 (Large).JPG
IMG_2391 (Large).JPG
IMG_2392 (Large).JPG
You do not have the required permissions to view the files attached to this post.