Quartzmatic DSM & LCD Salesman Samples

[BENRUS]

These were given to me today Thank you Les!
The one that looks like it's running with module is a faux taped on paper display...No module.
Does anyone have a spare module for the top button version?

2015-05-11 12.32.11.jpg

2015-05-11 12.51.52.jpg

2015-05-11 12.33.10.jpg

[Kasper]

Great Catch,,hmmm ..very difficult to find Mat.

[charger105]

Yeah, awesome Quartzmatic Matt !
I don't think that module was used in any other watch

In case you haven't found it already, see here for an image of what you're after (courtesy of Adam/DWL):
http://www.digital-watch.com/?ACT=34&fi ... board_id=1

You could always take a photo of his display and tape it to the inside of the case
Rgds.

[BENRUS]

Thanks Kasper
I'm guessing it never had a module. Most likely it had a faux DSM image taped to to underneath side of crystal because it was a dealer display piece.
The square back to this watch is supposed to have a battery hatch, and there is no Westclox logo at the bottom.
Good idea charger105!
I may try printing a similar DSM display image, and get a new glass cut for it for display.

[Adam]

Sorry I cant help Matt. If you need a print out you can use this or I can try and take one straight on(if its still working)

Adam

quartzmatic_DSM.jpg

[BENRUS]

Thanks Adam
You need to add your watch to the Library!
Its destined for new pictures

Best regards,
Matt

[BENRUS]

Here's a picture of it cleaned up a bit

johnhigbyyoyofactoryhubstackquartzmatic.jpg

2015-05-13 11.38.54.jpg

I'm making some small DSM display image prints, and I'm trying to figure out what to use for the crystal yet
I have some thin glass, and a cutter/scorer...just no skill in snapping yet. I also have some thin plexiglass, which I could try working with.