12 Nov 2019, 20:50
Aloha Adam, yes I believe so the module was behaving erratically and setting the time was almost impossible. Normally in the setting mode one button would increment the value and the other button would change the setting mode (Hr, Min, Date..etc), in this case pressing the increment button did two things, it incremented the value then changed the setting mode. So just trying to set the Hr I would have to cycle through the min, date and Hr over an over. I thought maybe there was a short on the logic board and tried to re-solder some of the connections but again it would react erratically.
I then worked on the LCD mounting thinking perhaps not all pins were contacting the display. Well through that process the LCD display started to bleed. That's when I decided to put everything away and wait for a donor module. I was fortunate to find someone selling their 0635-5009 watch for parts as shown. I was pleased to see that both the logic board and display was working perfectly.
You do not have the required permissions to view the files attached to this post.